Iiyama AQU5611DTBK User Manual download pdf (Page 16)

Connecting the digital signal cable

1. Make sure that the video graphics card is installed on your computer.

2. Make sure that the power cord is NOT connected to your computer.

3. Open the cover of your computer, if necessary.

4. Connect the connector end marked ″1 PRIMARY″ to the DVI port marked ″1″,

and the connector end marked ″2 SECONDARY″ to the DVI port marked ″2″ of

the video graphics card.

5. If you have opened the cover of your computer, close it.

Notes:

a. If you want to use the extended function, then install the program to your

computer now if you have not installed it yet. Then connect the USB

connector to the USB port. If you don’t have this program, you can

download it from the following Web site: http://www.iiyama.co.jp

b. Do not connect the USB connector to the USB port if you don’t have the

extended function program installed on your computer. Connecting this

connector may damage your monitor, computer, or other attached USB

devices.

c. If your video graphics card has only one DVI port, then connect the

connector of the digital signal cable marked ″1 PRIMARY″ to the DVI port on

the video graphics card of your computer.

d. With the ATI

FireGL

™

4 video graphics card, use ATI device driver version

2078 (or higher) for the best performance of the monitor. The device driver

is available at the following Web site: http://support.ati.com

8 AQU5611D BK/AQU5611DT BK 9.2 Million Pixels Color TFT LCD Monitor USER MANUAL

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 45 46

No comments

Iiyama AQU5611DTBK User Manual Page 16